Reset Home
[sets OnStep position to home after physical telescope movement to home]
5.6.1.4 Parking
Park
[move telescope to park position (default is home position) and save the alignment
model in preparation for power down]
Un-Park
[when powered up at park position following use of Park command in previous
session, restores the alignment model and starts tracking]
Set-Park
[used to define a custom park position at the current axis locations]
5.6.1.5 Tracking
Start / Stop
[The following 3 selections set the tracking rate to the standard for stellar objects, the
sun or the moon]
Sidereal
Solar
Lunar
Rate Reset
[Reset tracking rate to a standard rate]
[use the following to adjust tiny tracking rate errors due to gearing parameter
inaccuracies]
Rate +0.02Hz
Rate -0.02Hz
5.6.1.7 Settings
Date/Time
[Set local date and time. Questions are asked about whether the time was AM or PM
(if the SHC was configured with DISPLAY_24HR_TIME OFF) and whether the time
was a DST-adjusted time]
Site
Select Site
[Select one of 4 user-defined sites. If the controller gets site data from a GPS,
when received it is always stored in 'Site 1' with the name of 'GPS']
Latitude
18
To Next Page
Loading...
