Longitude
UTC Offset
[this is the inverse of your timezone offset, e.g. +5 for North American
Eastern which is defined as -5 as a time zone. Do not adjust this for
Daylight/summer time... the stars don't care about that]
Display
Turn off
[Press any key to turn on. That first key press is ignored so there's no worry it
will cause a telescope motion]
Contrast [also known as brightness]
Min, Low, High, MAX
Dim Timeout
[dims display after key inactivity interval]
Disable, 30 or 60 seconds
Blank Timeout
[blanks display after key inactivity interval. On the wireless SHC it is
advisable to use '1 minute' so that the unit spends the maximum amount of
time in low-power mode.]
Disable, 1, 2, 3, 4 or 5 minutes
Buzzer [On or Off]
5.6.1.8 Configuration
Goto Speed
[Sets the Goto speed to 2x, 1.5x, 1x, .75x or .5x of the configured
SLEW_RATE_BASE_DESIRED, respectively]
Fastest, Faster, Default Speed, Slower, Slowest
Backlash
[sets gear backlash for axis 1 and 2]
Axis1 RA/Az, Axis2 Dec/Alt
Limits
Horizon Limit
[Sets number of degrees telescope is allowed to point below the horizon while
tracking or slewing]
Overhead Limit
19
To Next Page
Loading...
