168 Driving and operation
Wheels, tyres
Suitable tyres and restrictions 3 264.
Tyres fitted in the factory are adapted to
the chassis and provide optimum driving
comfort and safety.
Changing tyre/wheel type
If tyres of a different size than those fitted
at the factory are used, it may be
necessary to reprogram the electronic
speedometer and make other vehicle
modifications.
After converting to a different tyre size,
have the adhesive label with tyre pressures
replaced.
Vehicles with run-flat tyres
3
When switching wheels, e.g. when
switching to winter tyres, use run-flat tyres
as there is no spare wheel or tyre repair kit
in the vehicle.
Vehicles with engine Z 10 XEP: Run-flat
tyres are not permitted for all rear axle
applications. We recommend your Opel
Partner.
Run-flat tyres 3 3 171.
Fitting new tyres
Fit tyres in pairs or in sets, which is even
better. Ensure that tyres on one axle are
z the same size,
z the same design,
z the same make,
z and have the same tread pattern.
Fit directional tyres such that they roll in the
direction of travel. The rolling direction is
indicated by a symbol (e.g. an arrow) on
the sidewall.
Tyres fitted opposing the rolling direction
(e.g. when a tyre is changed) should be
refitted as soon as possible. This is the only
way to obtain full benefit from the design
properties of the tyre.
Run-flat tyres 3 mu st not be combined with
conventional tyres.
Pay attention to legal requirements when
disposing of tyres.
9 Warning
Use of unsuitable tyres or wheels may
lead to accidents and render the vehicle
unroadworthy.
To Next Page
Loading...
