Openpath Core Series - Network Settings




b. Click on the Add ACU Expansion Board dropdown, select Openpath 
ACU , and click Add 
c. Click Save 
6. Hold down the ADMIN button for three seconds 
7. In the Control Center, click the blue Register next to the name of your ACU 
8. Click Yes to proceed 
9. A new window will open, click Provision 
10. If you see a "This Site Cannot be Reached" error, you need to ping the ACU 
using the command line: 
a. Open a command prompt and run: 
i. On Windows: ping oppi.local 
ii. On Mac or Linux: ping -c4 oppi.local 
● If nothing returns, check your network requirements. See 
NETWORK REQUIREMENTS . 
b. You should see the ACU's IP address (either in IPv4 or IPv6 format). Copy 
the address and return to the error page. 
c. In the URL, delete everything before :8080 
i. If using an IPv4 address, paste before :8080. For example: 
192.0.2.0:8080 
ii. If using an IPv6 address, delete the last two digits and the 
percentage sign, put square brackets outside the address, and 
paste before :8080. 
● Correct: [a123::b456:5a18:eb8f:7fd6]:8080 
● Incorrect: a123::b456:5a18:eb8f:7fd6%29:8080 
iii. Hit Enter , then click the Provision button 
iv. If the Provision button still doesn't appear, contact Openpath 
Support at (844) 673-6728 Ext 2 or support@openpath.com . 
NETWORK SETTINGS 
In the Open Admin app, you can configure network settings for the ACU. 

To change network settings: 

1. Connect to the ACU by pressing the Admin button again if needed 
2. Tap on Network Settings 
3. Select Configure network manually 
4. Configure the network settings as needed — set a static IP address or set a 
preferred DNS server 
5. Tap Save on the top right of the screen 

Version 1.8 
© Openpath 2020 
Page 32 
