Opex DS2200 - Adjusting Image Quality; Rescanning Documents

Operating the System 51
DS2200 User Manual - OPEX Corporation use only - not for distribution
Adjusting image quality
Fine-tune the quality of the document images by pressing Adjust on the Run
screen. The Adjust Capture Parameters screen will appear, where you can
modify the brightness and dropout colors for the images.
Table 1 describes the Adjust Capture Parameters screen buttons.
Rescanning documents
If you are not pleased with a particular image, you can rescan the document
while the job is running. To rescan a document:
1 Select the document’s thumbnail.
Table 1: Adjust Capture Parameters screen buttons
Brightness
Adjust the brightness of the document images from Light to
Dark. Press a button to adjust the brightness. The default is
Normal.
Dropout
Remove a dropout color (Red, Green, Blue, or White) from the
document image. The color you select will appear as white.
The default is White.
Note: To use this feature, the documents must be printed with
a specific dropout color.
Adjust All/
Adjust One
Select Adjust All to apply these changes to all the documents
in the current job, or Adjust One to make the adjustments only
to the next document scanned.
Defaults Return to the default capture parameters.