Statistics 75
DS2200 User Manual - OPEX Corporation use only - not for distribution
Figure 25: Statistics Reports Criteria screen
2 For this exercise, click the Summary Report button at the bottom of the
screen.
3 In the Statistics Reports Criteria window, set the parameters for the report
as shown in Figure 25:
- Jobs - select the job(s) for which you want to run a statistics report.
- You can select several individual jobs for a single report, however, if you
click All Jobs, it automatically deselects the individual jobs (since they
would be included in the “All Jobs” category).
- Operators - select the operator(s) and/or the shift for which you want to
run a statistics report.
- You can select several individual operators for a single report, however,
if you click All Operators, it automatically deselects the individual
operators (since they would be included in the “All Operators” category).
- Clicking any one of the Shift options will select all operators during that
scheduled shift. The default setting, All Operators, includes all shifts.
- Date - set the start and end date for the report. In Figure 26, the Summary
report was run for a single day, but virtually any range can be selected.
- Time - set the start and end time for the report. In Figure 26, these
parameters were set to include the 3rd shift (12:00 AM-8:00 AM) and the
first shift (8:00 AM to 4:00 PM).
- Job/Operator Lists - select one of the radio buttons:
To Next Page
Loading...
