Opex DS2200 - Page 85

Statistics 85
DS2200 User Manual - OPEX Corporation use only - not for distribution
Vertical Turn Sensor
Missing
Results when the controller is expecting to see a
piece pass by the vertical turn sensor but it has
not within the time period that we are expecting
it.
Stacker Entry Sensor
Missing
Results when the controller is expecting to see a
piece pass by the stacker entry sensor but it has
not within the time period that we are expecting
it.
Bin 2 Gate Sensor
Missing
Results when the controller is expecting to see a
piece pass by the bin 2 gate sensor but it has
not within the time period that we are expecting
it.
Bin 3 Gate Sensor
Missing
Results when the controller is expecting to see a
piece pass by the bin 3 gate sensor but it has
not within the time period that we are expecting
it.
Bin 4 Gate Sensor
Missing
Results when the controller is expecting to see a
piece pass by the bin 4 gate sensor but it has
not within the time period that we are expecting
it.
Bin 5 Gate Sensor
Missing
Results when the controller is expecting to see a
piece pass by the bin 5 gate sensor but it has
not within the time period that we are expecting
it.
Feed Entry Multifeed
Sensor Blocked
The Feed Entry MultiFeed Sensor is blocked.
Feed Input Multifeed
Sensor Blocked
The Feed Input MultiFeed Sensor is blocked.
Unexpected Piece at
Stacker Entry Sensor
Results when a piece is detected at the stacker
entry sensor that the software was not
expecting. This is usually caused by a piece that
was intended to go to the stacker bypass bin but
did not make the correct decision in time. A gate
that did not fire properly can also cause it.
Table 6: Reasons for jams (continued)