Opticon
C37
Specifications Manual
11
5.3.2. Output Specifications
Parameter Value
Output voltage 6.0 V ±5%
Power ripple 120 m Vp-p max. (rated load)
Maximum current 2 A
Short-circuit protection Available
Conditions
• Connect 1Ω resistance to a power supply line in series and measure the current
by the voltage between both ends of resistance.
• Power supply voltage is measured at a connector terminal area.
• The current value depends on the interface type and host computer to which the
device is connected.
6. Optical Specifications
6.1. CCD Specifications
Parameter Specification Unit
Light-emitting element Red LED —
Emission wavelength 630 ±10 (25° C) nm
Scanning method CCD Linear Image Sensor —
Scanning speed 200 ±20 scans/s
Number of pixels 2500 —
Notes:
Refer to chapter 15, “Trigger and Read Options,” to read about the scan modes.
Refer to chapter 7, “Technical Specifications,” to read about scanning performance.
To Next Page
Loading...
