Opticon C 37 - USB-HID and USB-VCP Interface Specifications; Settings; Interface Circuit; DOS;V Wedge Interface Specification

Opticon
C37
Specifications Manual
21
8.2. USB-HID and USB-VCP Interface Specifications
8.2.1. Settings
Reading the menu barcodes in section 10.1 can set the USB interface default.
The interface is full-speed USB (12 Mbps).
Note: You must install the USB-VCP driver on the host.
8.2.2.
Interface Circuit
Figure 15: Interface circuit
Do not use the keyboard while the scanner is transmitting the data to the host.
Doing so may cause failure in data transactions.
8.3. DOS/V Wedge Interface Specification
Reading the menu barcodes in section 10.1 can set the DOS/V Wedge interface default.
For either interface (USB or HID/Wedge)—Set the language for the scanner and PC
keyboard to the same language before use; otherwise, the output may not be correct.