OPN2002/3/4 Application Manual
RFG35416, RFIS0940
— 4 —
Installing Drivers
USB-VCP Drivers
To be able to communicate with the OPN200x terminals using USB-VCP, you will need to have the USB driver installed on your PC. This driver can be downloaded
from the following link.
http://ftp.opticonusa.com/Downloads/USB%20Drivers%20Installer.zip
USB Drivers Installers.exe USB-VCP driver for Windows 2000 , Windows XP (32bit) & Windows Vista/7 (32bit)
USB-VCP driver for Windows XP (64bit) & Windows Vista/7 (64bit)
USB driver for the CRD2002
After installing the USB driver, you can connect your OPN to USB using the mini-USB cable. Windows will then automatically install a virtual COM port on your
PC, which must be selected in various applications, like Appload, Hyperterminal and Neto32.
CRD2000 Cradle Drivers (OPN2002 Only)
The CRD2000 cradle works either via USB or via RS232 and both interfaces do not require any configuration.
The USB-VCP driver pack mentioned above also automatically installs the USB drivers for the CRD2002 cradle.
Using the Mass Storage Device (MSD) Interface
When the USB-MSD interface has been selected, the OPN will behave like a portable mass storage device when it is connected to USB.
Any scanned barcodes will be stored in a comma separated file called ‘DATA.TXT’, which can be copied/moved from the OPN using a file browser.
Due to the limited amount of memory (RAM) inside the OPN, the size of the file system is rather small, about 32kB on the OPN2004, 125kB on the OPN2003, and
about 900kB on the OPN2002. This is ample space for storing barcodes, but not for using the OPN as a portable hard drive.
To Next Page
Loading...
Need help?
General
