PULSAR Minimal Stress Installation and operating Manual
OPTIKON 2000
Cod. 111001EN 2012-02-16 Rev.J
5-5
5.3 CIRCUIT DIAGRAMS
Optikon 2000 S.p.A. will make available on request circuit diagrams, component part lists,
descriptions, calibration instructions, or other information which will assist the user's
appropriately qualified technical personnel to repair those parts of equipment which are
repairable.
5.4 EMC TABLES
5.4.1 GUIDANCE AND MANUFACTURER’S DECLARATION – ELECTROMAGNETIC EMISSIONS
The Pulsar MS is intended for use in the electromagnetic environment specified below. The
customer or the user of the Pulsar MS
should assure that it is used in such an environment.
Emissions test Compliance Electromagnetic Environment – Guidance
RF emissions
CISPR 11
Group 1
The Pulsar MS uses RF energy only for its
internal function.
Therefore, its RF emissions are very low and are
not likely to cause any interference in nearby
electronic equipment.
RF emissions
CISPR 11
Class B
The Pulsar MS is suitable for use in all
establishments including domestic
establishments and those directly connected to
the public low voltage supply network that
supplies buildings used for domestic purposes.
Harmonic emissions
IEC 61000-3-2
Class A
Voltage fluctuations/Flicker
emissions
IEC 61000-3-3
Complies
To Next Page
Loading...
