OPTIKON PULSAR MS - Page 70

PULSAR Minimal Stress Installation and operating Manual
OPTIKON 2000
Cod. 111001EN 2012-02-16 Rev.J
11-2
R
Reduction mode ....................... 8-8
Repetitive cutting mode ........... 8-12
Rise Time ............................... 8-8
S
"Save" key ............................. 8-20
"Save as" key ......................... 8-20
Single burst ............................. 7-4
Single cut ...................... 8-11; 8-12
Single linear mode .................. 8-17
Symbols ................................. 4-1
T
Test chamber .......................... 8-8
Timer reset ............................. 8-7
To recall or store a program ....... 8-19
To create and store a new
program ............................... 8-19
To select a pedal ............. 8-14; 8-22
Tuning ................................... 8-9
U
U/S screen ..............................8-6
U/S (phaco) socket ....................7-5
UNDO key ............................. 8-21
Unit’s ground connector ..............7-8
User interface ..........................7-8
V
VAC CONTROL key .....................8-5
Vacuum level ......................... 8-19
Venting and reflux pinch valve ......7-6
Vitrectomy (VIT) .......................7-2
Vitrectomy screen ................... 8-11
Vitrectomy socket .....................7-6
Volume control knob ..................7-7
VOLUME CONTROL KNOB .............7-7
W
Warnings ................................3-1
Warranty ................................2-1
Waste collection tank supports .....7-7