OPTIMUM
MASCHINEN - GERMANY
Assembly
30 / 11 / 2007 Page 31Assembly Add-on kit D240/D280 ; Version 1.3.3
© 2007
GB
£ Screw the splash board with 2
screws on the terminal block.
£ Properly close the terminal block
after screwing the splash board.
Illustr.: 4-66: Assembly splash protection
£ Screw the splash board with two
screws to the lathe bed.
Illustr.: 4-67: Assembly splash protection
£ Screw the support for the lathe
chuck protection to the spindle head
again.
Illustr.: 4-68: Support lathe chuck protection
Fastening screws
Splash board
Splash board
Fastening screw
Support lathe chuck
protection
Fastening screw
To Next Page
Loading...
