Description of the basic operation
OPTIMUM
MASCHINEN - GERMANY
15 / 06 / 2011Page 22 Description of the basic operation Digital position display DPA 2000/ DPA 2000S ; Version 2.1.2
© 2011
GB
4 Description of the basic operation
Description:
Standard display mode:
Refers to the situation when only one display light on the left of the display window is
illuminated, all display lights on the right side of the display window are switched off and all axes
displays do not flash in their current position respectively the display lights beside the keys
, , and and the display light of the selected axes is illumiated.
4.1 Initiation
Function introduction: Switch on position display using the ON/OFF switch, the position display
will start the self-test mode and during this process the LED will show the following items:
A. The position display serial number;
B. Company name;
C. Software version;
After finishing the self-test, the position display
switches to the normal display mode.
While working normally, the position display will memo-
rize:
A. The position of the position display when it had been
last switched off;
B. The selected coordinates and the selected cutter
when the position display had been last switched off;
C. The mm-/inch system the position display has used.
4.2 Deleting
Function introduction: When the position display is in the normal display mode, to delete the
value displayed on the coordinate axis.
Operation procedures:
Return to the normal display mode;
Press the key, select the X-axis, then press the
key, delete the X-axis;
Press the key, select the Y-axis, then press the
key, delete the Y-axis;
Press the key, select the Z0/Y-axis, then press the key, delete the Z0/Y-axis;
Press the key, select the Z-axis, then press the
key, delete the Z-axis.
To Next Page
Loading...
