Safety
OPTIMUM
MASCHINEN - GERMANY
15.6.11Page 4 Safety Digital position display DPA 2000/ DPA 2000S ; Version 2.1.2
© 2011
GB
1 Safety
Glossary of symbols
This part of the operating manual
explains how to use the device properly,
points out dangers which might come into existence when disregarding this operating
manual,
informs you about how you can avoid dangers.
In addition to this operating manual please observe
the applicable laws and regulations,
the legal regulations for accident prevention,
the prohibition, warning and mandatory signs as well as the warning notes on the device.
Dring installation, operation, maintenance and repair of the device the applicable standards and
country-specific regulations of each country need to be observed.
ALWAYS KEEP THIS OPERATING MANUAL CLOSE TO THE DEVICE.
INFORMATION
If you are not able to solve a problem by using this manual, please contact us under:
Optimum Maschinen Germany GmbH
Dr. Robert-Pfleger-Str. 26
D- 96103 Hallstadt
E-Mail: info@optimum-maschinen.de
Technical Hotline: 09 00 - 19 68 220 (0.49 €/min if you call from the German fixed network,
this information is dated at the time of printing)
1.1 Target group
This operating manual is addressed to operation organizations, the operators and the main-
tenance staff.
1.2 Proper use
WARNING!
In the event of improper use, the digital position display
• will endanger personnel,
• will endanger the device and other material property of the operator,
• may affect proper operation of the device.
The device provided for the position display of traveling tools respectively tool slides on lathes,
milling machines, etc. The device is designed and manufactured to be used universally in
environments where there is no potential danger of explosion. For the operation, additionally
absolute or incremental measuring systems for the position acquisition are required.
gives additional indications
calls on you to act
enumerations
To Next Page
Loading...
Need help?
General
