Optimum DPA 2000 - 1 Safety; 1.1 Target Audience and Proper Use

OPTIMUM
MASCHINEN - GERMANY
Table of contents
15.6.11 Page 3Table of contents Digital position display DPA 2000/ DPA 2000S ; Version 2.1.2
© 2011
GB
4.12 Dividing hole along an oblique line function ......................................................... 26
4.13 Dividing hole on the circle function ....................................................................... 28
4.14 Machining along the oblique line function ............................................................ 30
4.15 Arc machining function ......................................................................................... 31
5 Internal parameter setting
5.1 Programming function .......................................................................................... 35
5.2 Setting the cutting linear speed and the workpiece diameter ............................... 37
6 Dimensions and mounting
7 Troubleshooting
8 Appendix
8.1 Copyright .............................................................................................................. 43
8.2 Warranty ............................................................................................................... 43
8.3 Disposal ............................................................................................................... 44
8.4 Product follow-up ................................................................................................. 44
8.5 EC Declaration of Conformity ............................................................................... 45