Delivery, interdepartmental transport, assembly and commissioning
Version 1.0.2 - 2020-07-0720 Translation of original instructions
DP26
EN
DP26_GB.fm
INFORMATION
The mains plug of the drilling machine must be freely accessible.
3.4.1 Fixing
In order to achieve the stability of the drilling machine, the machine should be connected to the
subsurface. For this purpose there are through holes at the foot of the drilling machine.
ATTENTION!
Tighten the fixing screws of the drilling machine only as much that it is safely fixed and
cannot break away or tilt over.
If the fixing screws are too tight in particular in connection with an uneven substructure it may
result in a broken stand of the machine.
Img.3-1: Fastening
3.5 First commissioning
WARNING!
There is a danger to persons and equipment, if the first commissioning of the drilling
machine is carried out by inexperienced personnel.
We do not accept any liability for damages caused by incorrectly performed commis-
sioning.
WARNING!
Risk from using improper workpiece clamping materials or operating the machine at an
inadmissible speed.
ATTENTION!
Before initially operating the machine, check all screws, fixtures and/or safety devices
and tighten up the screws if necessary!
Upright drilling machine
Bench drill
To Next Page
Loading...
Need help?
General