Optimus SYSTEM 730 - Reviewing a Programmed Sequence

22
5. Press
PLAY
, or
CD
on the
remote control, to play the pro-
grammed sequence. ,
P-01
,
and the first programmed CD
and track number appear. Then
the CD’s elapsed play time
appears, and the first track
begins to play.
Note
: To briefly stop pro-
grammed play, press
PAUSE
on the main system. appears
on the display. To resume pro-
grammed play, press
PLAY
,
or
CD
on the remote control.
disappears.
6. Programmed play automatically
stops at the end of the last pro-
grammed track. To stop the CD
changer at any time during pro-
grammed play, press and
release
STOP
, or press
CD
on the remote control.
and the CD’s elapsed play time
disappear from the display.
Notes
:
• Press
PLAY
, or
CD
on the
remote control, to play the pro-
grammed sequence again.
• To replace a programmed track,
press
RECALL
on the remote
control until the memory number
of the track you want to replace
appears on the display. Then
repeat Steps 1-3 to store a new
track.
• To resume regular or random
play after storing a programmed
sequence, you must first erase
the programmed sequence (see
“Erasing a Programmed Se-
quence”).
Reviewing a Programmed
Sequence
To review a programmed sequence,
while play is stopped, repeatedly
press
RECALL
on the remote control.
As you press it, the CD, track num-
ber, and memory position of each
stored track appears.
13-1277.fm Page 22 Wednesday, July 14, 1999 4:11 PM