7
PREPARATION
Important
: Complete all other con-
nections to the System 730 before
you connect it to power.
CONNECTING THE
SPEAKERS
1. Press open the pair of terminal
tabs marked
MAIN SPEAKERS/
+
R –
on the back of the System
730, then insert the right
speaker’s red wire into the red
(+) terminal and its black wire
into the black (–) terminal. Then
release the tabs.
Caution
: To avoid damaging
your system and speakers,
never let the speaker wire’s bare
ends touch each other.
2. Repeat Step 1 to connect the left
speaker’s wires to the terminals
marked
MAIN SPEAKERS/
+
L –
.
Note
: You can use the set of termi-
nals marked
SURROUND SPEAKER
to connect surround sound speakers
(not supplied) to your System 730.
Your local Radio Shack sells a wide
selection of surround sound speak-
ers.
Speaker Placement
For the best stereo effect, place the
speakers so the distance between
them is the same as the distance be-
tween the listening area and the point
halfway between the speakers. You
might want to experiment with sever-
al locations to find the best one.
Notes
:
• If the you place the speakers far
apart, you can improve the ste-
reo effect by angling the speak-
ers toward you.
• To increase the bass sound,
place the speakers in the corner
of the room, against the wall or
directly on the floor.
• To decrease the bass sound,
move the speakers slightly away
from the corner, increase the
distance between them, and/or
raise them 6 to 8 inches off the
floor. You can purchase speaker
stands at your local Radio
Shack store.
13-1277.fm Page 7 Wednesday, July 14, 1999 4:11 PM
To Next Page
Loading...