Optimus SYSTEM 746 - Timer Operation; Setting the Clock; Setting a Wake-Up Time

12
TIMER OPERATION
SETTING THE CLOCK
1. With power turned on, press
CLOCK
until the hour and minute
digits appear.
2. Press
MEMORY
.
The hour and
minute digits flash.
3. Within 10 seconds, press
HOUR
(or
TUNING
on the re-
mote control) to set the desired
hour.
4. Press
MIN
(or
TUNING
on
the remote control) to set the de-
sired minute.
Notes:
• If the hour and minute digits
stop flashing before you finish
illustration
illustration
illustration
illustration
setting the time, start again
from Step 1.
• To rapidly increase or de-
crease the hour or minute set-
ting, hold down
MIN
and
HOUR
(or
TUNING
and
on the remote control).
5. Press
MEMORY
again or wait un-
til the display stops flashing.
The system always displays the time
while power is turned off. To display
the time at any time while power is
turned on, press
CLOCK
.
SETTING A WAKE-UP
TIME
You can set your system to automat-
ically turn itself on (like an alarm
clock) and play the last selected ra-
dio station, a CD, or a cassette tape.
Note:
To quickly set the wake-up
timer using the last selected system
settings (radio station, volume level,
and so on; except if the cassette
deck is selected), you can leave the
power turned off and skip Steps 5–7
and 9.
1. Press
CLOCK
until
TIMER ON
and the last set wake-up time
appear. Then press
MEMORY
.
2. Press
MIN
and
HOUR
(or
TUNING
and on the re-
mote control) to set the wake-up
time.
13-1294.fm Page 12 Wednesday, July 14, 1999 7:01 PM