Optoma EP776 - Setup Procedure (VGA Port); DDC Key-In Procedure (VGA1,VGA2,DVI Interface)

EP776 Series/EP782 Series
Condential
6-3
6-4 DDC Key-In Procedure
(VGA1,VGA2,DVI
Interface)
1. Click on "EDID" to execute EDID program
2. Choose model
- In the port selection bar, please choose
the port that you use. Example: if you
use "COM2," choose COM2 in the port
selection.
- Click "Model."
- Choose the EDID that responses to the
model that you choose.
6-3 Setup Procedure (VGA
Port)
1. Connect all ports
- Power adapter to xture JP2
- Fixture P1 to PC COM Port
- Fixture P4 to Projector VGA1 in
- Fixture P2 to Projector VGA2 in
- Fixture P3 to Projector DVI
- Power on xture
- Plug in power cord to unit
Note: Conrm JP3 is “Close” status.
JP2
Adapter
RS232 Cable
P1
VGA-VGA Cable
P4
P2 P3
DVI-DVI Cable
2