Optoma HD70 - Powering the Projector On and Off

13
English
Installation
Powering On the Projector
1. Remove the lens cap. 
2. Ensure that the power cord and signal cable are securely
connected.  The Power LED will flash green.
3. Turn on the lamp by pressing “On/Standby” button
either on the top of the projector or on the remote. The
Power LED will turn green.
The startup screen will display in approximately 30 sec-
onds. The first time you use the projector, you can select
your preferred language from quick menu after the
startup screen display.
4. Turn on your source (computer, notebook, video player,
etc.). The projector will detect your source automati-
cally.
If you connected multiple sources at the same time, press the
“Source” button on the control panel or direct source key on the
remote control to switch between inputs.
Powering On/Off the Projector
Turn on the
projector first and
then select the
signal sources.
2
On/Standby
Lens Cap
1
Power LED