42
English
Appendices
Please note that
damage resulting
from incorrect instal-
lation will invalidate
the warranty.
Ceiling Mount Installation
1. To prevent damaging your projector, please use the
ceiling mount package for installation.
2. If you wish to use a third party ceiling mount kit,
please ensure the screws used to attached a mount to
the projector met the following specifications:
Screw type: M3
Maximum screw length: 10mm
Minimum screw length: 7.5mm
Warning:
1. If you buy the ceil-
ing mount from other
company, please
ensure that there is
at least 10cm distance
between the bottom
cover of the projector
and the ceiling.
2. Avoid placing the
projector near sources
of heat such air-con-
ditioning units and
heaters otherwise it
may overheat and
shut down automati-
cally.
To Next Page
Loading...
