37
English
Appendices
Intermission Problems
The projector stops responding to all controls
If possible, turn off the projector, then unplug the power cord
and wait at least 30 seconds before reconnecting power.
Lamp burns out or makes a popping sound
When the lamp reaches its end of life, it will burn out and may
make a loud popping sound. If this happens, the projector
will not turn on until the lamp module has been replaced. To
replace the lamp, follow the procedures in the “Replacing the
Lamp” section on page 40.
LED Problems
LED lighting message
Message
On/Standby LED Temp-LED Lamp-LED
(Green) (Red) (Orange)
Standby State
(Input power cord)
Flashing
Power on (warming)
Lamp lighting
Power off (Cooling)
Error (Lamp fail)
Error (Fan fail) Flashing
Error (Over Temp.)
Steady light
No light
To Next Page
Loading...
