Install Windows Server 2012 or 2012 R2 Using PXE Network Boot
The server begins the boot process and the BIOS screen appears in the Oracle ILOM Remote
System Console Plus application.
Note - The next event occurs very quickly; therefore, focused attention is needed for the
following steps. Watch carefully for these messages as they appear on the screen for a brief
time. You might want to enlarge the size of your screen to eliminate scroll bars.
3.
To verify that PXE boot is enabled, perform the following steps:
Note - PXE boot is enabled by default; however, this step directs you to verify that PXE boot is
enabled in the event that it was disabled. Once you have verified that PXE boot is enabled, you
can omit this step on subsequent PXE boots.
a.
Press the F2 key to accesses the BIOS Setup Utility.
The BIOS Setup Utility appears.
b.
Select Advanced in the top menu bar.
The BIOS Setup Utility Advanced screen appears.
c.
Select Network Stack from the list of available options.
Installing a Windows Server Operating System 61
To Next Page
Loading...
