Install Windows Server 2012 or 2012 R2 Using PXE Network Boot
The BIOS Setup Utility Network Stack screen appears.
d.
If necessary, set the appropriate PXE Support setting (either IPv4 or IPv6) to
Enabled.
e.
To save the changes and exit the BIOS Setup Utility, press the F10 key.
This causes the server to reset. After resetting, the BIOS screen appears again.
4.
In the BIOS screen, press the F8 key to specify a temporary boot device or press
F12 to network boot (PXE).
The Please Select Boot Device menu appears listing the available boot devices. The screen that
appears will differ depending on whether you have BIOS configured for Legacy BIOS Boot
Mode or UEFI Boot Mode.
■
For Legacy BIOS, a screen similar to the following appears:
62 Oracle Server X5-2 Installation Guide for Windows Server Operating Systems • April 2016
To Next Page
Loading...
