Oracle Sun Fire X2270 M2 User Manual

Maintaining the Sun Fire X2270 M2 Server
This section contains information that describes how to add, replace, and congure
components in the Sun Fire X2270 M2 Server after it has been set up:
■
“Preparing for Service and Operation” on page 17
■
“Powering On and Powering O the Server” on page 27
■
“Component Replacement Procedures and Topic” on page 29
Preparing for Service and Operation
This section contains important topics and tasks that describe how to safely and properly
prepare your server for both service and operation.
Note – System cooling might be aected by dust and contaminant buildup. Open and check the
server approximately every six months or more often in dustier operating environments. Check
system heatsinks, fans, and air openings. If necessary, clean systems by brushing or blowing
contaminants from the system or by carefully vacuuming contaminants from the system. Do
not use liquid cleaners on or in the server.
■
“Important Safety Information” on page 17
■
“Antistatic Procedures and Precautions” on page 18
■
“How to Use an Antistatic Mat” on page 19
■
“CRU and FRU List” on page 19
■
“Tools and Supplies Needed” on page 20
■
“How to Prepare for Service” on page 21
■
“How to Remove the Server from the Rack” on page 22
■
“How to Install the Server Into the Rack” on page 23
■
“How to Remove the Server Cover” on page 25
■
“How to Install the Server Cover” on page 26
■
“How to Prepare for Operation” on page 26
Important Safety Information
This section describes important safety information to know before removing or installing
parts in your Sun Fire server.
17

Oracle Sun Fire X2270 M2 Specifications

General

Brand	Oracle
Model	Sun Fire X2270 M2
Category	Server
Language	English