Set the server on a at stable surface.
If necessary, push the extended rails into the rack.
“How to Install the Server Into the Rack” on page 23
“How to Remove the Server Cover” on page 25
▼
How to Install the Server Into the Rack
Use this procedure to install the server chassis, with mounting brackets, into the slide rail
assemblies that are mounted to the rack.
Caution – This procedure requires a minimum of two people because of the weight of the server.
Attempting this procedure alone could result in equipment damage or personal injury.
Caution – Always load equipment into a rack from the bottom up so that it does not become
top-heavy and tip over. Deploy your rack’s anti-tilt bar to prevent the rack from tipping during
equipment installation.
Ensure that the slide rails and the slide rail assemblies are fully collapsed into the rack.
Push the slide rails into the slide rail assemblies and then collapse the assemblies.
10
11
See Also
Next Steps
1
Tools and Supplies Needed
23
To Next Page
Loading...
Need help?
General