Oracle Sun Fire X2270 M2 - Replacing a Blower Module (CRU)

Position the air duct in the chassis, aligning the bae with the indents and opening in the
chassis divider.
Carefully lower the air duct in place.
Prepare the server for operation. See
“How to Prepare for Operation”on page 26.
■
“How to Remove the Air Duct” on page 53
Replacing a Blower Module (CRU)
The following procedures describe how to replace a blower module. The X2270 server contains
three blower modules.
■
“How to Remove a Blower Module” on page 54
■
“How to Install a Blower Module” on page 55
▼
How to Remove a Blower Module
See:
■
“Sun Fire X2270 M2 Server Internal Cabling” on page 61
■
“Locations of Internal Server Components” on page 30
1
2
3
See Also
BeforeYou Begin
Replacing a Blower Module (CRU)
Sun Fire X2270 M2 Server Service Manual • January, 2012, –1254