Oracle Sun Fire X2270 M2 - Page 55

Prepare the server for service. See “How to Prepare for Service”on page 21.
Remove the air duct. See
“How to Remove the Air Duct”on page 53.
Unplug the blower’s power connector from the motherboard.
Pull the blower upward while pushing the connector cable through the cutout in the chassis
divider and taking care not to catch the connector on the metal, to remove the blower from the
chassis.
Caution – Thermal over-temperature potential. Do not operate the server without all airow
components installed.
■
“How to Install a Blower Module” on page 55
▼
How to Install a Blower Module
See:
■
“Locations of Internal Server Components” on page 30
■
“Sun Fire X2270 M2 Server Internal Cabling” on page 61
1
2
3
4
See Also
BeforeYou Begin
Replacing a Blower Module (CRU)
55