Replacing the SATA Cable Harness (CRU)
This section contains the following topics:
■
“How to Remove the SATA Cable Harness” on page 62
■
“How to Install the SATA Cable Harness” on page 62
▼
How to Remove the SATA Cable Harness
See:
“Sun Fire X2270 M2 Server Internal Cabling” on page 61.
Prepare the server for service. See
“How to Prepare for Service”on page 21.
Remove the air duct. See .
“How to Remove the Air Duct”on page 53.
Disconnect the four SATA cables from the backplane.
Disconnect the four SATA cables from the motherboard connections.
Release the SATA cable harness from its tie-down points.
Carefully pull the SATA cable through the cutout in the chassis divider and lift it from the chassis.
“How to Install the SATA Cable Harness” on page 62
▼
How to Install the SATA Cable Harness
See:
“Sun Fire X2270 M2 Server Internal Cabling” on page 61.
Match the color-coded SATA cables with their associated motherboard connections and connect
the SATA cable connectors to the motherboard.
Carefully route the SATA cable through the cutout in the chassis divider.
Match the color-coded SATA cables with their associated backplane connection and connect the
SATA cable connectors to the backplane.
Secure the SATA cable to the tie-down points.
Check the routing of all cables for obstructions.
BeforeYou Begin
1
2
3
4
5
6
Next Steps
BeforeYou Begin
1
2
3
4
5
Replacing the SATA Cable Harness (CRU)
Sun Fire X2270 M2 Server Service Manual • January, 2012, –1262
To Next Page
Loading...
