Oregon Scientific SE188 - Getting Started; Unpacking the Watch; Turning on the Watch (First-Time Use Only); Setting the Keypad Tone; Light Mode; Tap on Lens

4
EN
Area 2
1. MM:DD or DD: MM and day of the week; stopwatch time.
2.
/ : Alarm 1 and 2; waves show when alarm is
activated.
3.
: Cursor highlights the selected alarm in Alarm
Mode.
4. kcal: Calorie unit.
5.
: Light Mode is enabled.
6.
: Tap on lens is enabled.
Area 3
1. Time - HH:MM.
2. AM/PM: Appears when the 12-hour clock / alarm is
being used.
3. AVG: Average heart rate is displayed.
4. MAX: Maximum heart rate is displayed.
5.
: Heart rate is above or below limit; sound alert is
activated.
6. : Flashes when receiving heart rate signal.
7. kglbs: Body weight unit.
8. % FAT: Percentage of fat burn.
9. CM Yr: Height unit; year of user’s birth.
10. LAP: Take lap; lap number.
11. MEM: Stopwatch or timer memory is shown.
12.
: Battery status.
GETTING STARTED
UNPACKING THE WATCH
When you unpack your watch, make sure to keep all the
packing materials in a safe place, in case you need to later
transport or return the product for servicing.
In this box, you will find:
• Watch
• Heart rate chest belt
• Mounting bracket
• Carry case
• 2 x CR2032 lithium batteries - already installed
TURNING ON THE WATCH (FIRST-TIME USE ONLY)
Press any key for 2 seconds to activate the LCD display.
SETTING THE KEYPAD TONE / LIGHT MODE /
TAP ON LENS
You can set the watch to have the:
• Keypad “Beep” tone ON or OFF.