To Next PageTo Next PageWhat to do if the set rotation speed isn't saved on my Oriental motor BMU Engine?
If the set rotation speed isn't saving on your Oriental motor Engine, make sure to confirm the setting by pressing the setting dial after adjusting the rotation speed.
What to do if the Oriental motor BMU Engine is not reversed by the rotation direction switch?
If your Oriental motor Engine isn't reversing with the rotation direction switch, check the setting of the "external operation signal input" parameter to ensure it's correctly configured.
Why can't I perform settings using the setting dial on my Oriental motor BMU?
If you can't perform settings using the setting dial on your Oriental motor Engine, it's possible that the lock function has been enabled. Try releasing the lock function.
Why can't I increase the rotation speed of my Oriental motor Engine?
If you can't increase the rotation speed of your Oriental motor Engine, the speed upper limit might have been set. Try raising the speed upper limit.
General| Motor Type | Brushless DC Motor |
|---|---|
| Series | BMU Series |
| Insulation Class | Class B |
| Frame Size | 60mm, 80mm |
| Output Power | 15 W, 400 W |
| Power Supply | Single-Phase 100-120 VAC, Single-Phase 200-240 VAC, Three-Phase 200-240 VAC |
| Control Method | Speed control, Torque control, Position control |
| Gear Type | Planetary gear, Spur gear |
| Encoder | Incremental encoder (optional) |
| Protection | Overvoltage Protection |
| Voltage | 100VAC, 200VAC |
Instructions for handling that may result in serious injury, death, or property damage.
Explanation of graphic symbols and important notes for safe product use.
Steps for connecting connector-type motors and drivers, including cable extensions.
Instructions for connecting cable-type motors to the driver.
Essential steps for grounding the motor and driver for safety and performance.
Methods for connecting the driver to single-phase and three-phase power supplies.
Details on connecting I/O signals and CN4 pin configurations.
Methods for operating the motor and using the front panel controls.
How to operate the motor using external signals from a programmable controller.
Configuring and using multiple operation data settings for speed control.
Detailed guide to accessing and modifying driver parameters.
Comprehensive list of driver parameters, their settings, and factory defaults.
Methods for adjusting acceleration and deceleration time parameters.
Comprehensive list of alarm codes, their causes, and remedial actions.
Methods for resetting alarms after their cause is removed.
Solutions for problems like motor not operating or incorrect rotation.
Troubleshooting tips for speed display, setting, and saving problems.
Addressing unstable operation and excessive motor vibration.
Installing filters and using compliant power supplies for EMC.
Methods for grounding, shielding, and using ferrite cores for EMC.
