Oriental motor MSC-1 User Manual

Table of contents
HP-5051-7
Speed Controller
MSC-1
OPERATING MANUAL
Thank you for purchasing an Oriental Motor product.
This Manual describes product handling procedures and safety precautions.
•
Please read it thoroughly to ensure safe operation.
•
Always keep the manual where it is readily available.
1 Introduction ............................... 2
2 Safety precautions .................... 4
3 Precautions for use .................. 5
4 Installation ................................ 6
4.1 Location for installation .................6
4.2 Installation method ........................6
4.3 Installing an external
potentiometer (Sold separately) ....7
4.4 Installing and wiring in compliance
with EMC Directive ........................7
5 Connection ............................... 9
5.1 Connection example .....................9
5.2 I/O signals ...................................12
6 Basic operations ..................... 13
6.1 Run/stop ......................................13
6.2 Setting the operating speed ........13
6.3 Setting the acceleration time and
deceleration time .........................14
6.4 2-speed operation .......................14
6.5 Timing chart .................................15
6.6 Multi-motor control ......................15
6.7 Repeated cycle of operation/
instantaneous stop ......................16
6.8 Braking current at instantaneous
stop .............................................16
7 Alarms .................................... 17
8 Inspection ............................... 18
9 Troubleshooting and remedial
actions .................................... 19

Oriental motor MSC-1 Specifications

General

Brand	Oriental motor
Model	MSC-1
Category	Controller
Language	English

Summary

Introduction

Names and Functions of Parts

Details the names and functions of the speed controller's components and indicators.

Safety precautions

Precautions for use

Installation

Location for installation

Specifies the ideal environmental conditions and location requirements for installing the speed controller.

Installation method

Details the procedure for mounting the speed controller onto a DIN rail and securing it.

Installing an external potentiometer (Sold separately)

Provides instructions and diagrams for installing an optional external potentiometer.

Installing and wiring in compliance with EMC Directive

Explains methods for installation and wiring to meet EMC Directive requirements for electromagnetic compatibility.

Connection

Connection example

Provides a detailed wiring diagram for connecting the motor, power supply, and control DC power.

Basic operations

Run/stop

Explains how to start, stop, and instantaneously stop the motor using input signals.

Setting the operating speed

Details methods for setting motor speed using internal potentiometer, external potentiometer, or DC voltage.

Setting the acceleration time and deceleration time

Covers adjusting acceleration and deceleration times for smooth motor operation.

2-speed operation

Describes how to perform two-speed operation by switching between internal and external speed settings.

Timing chart

Presents timing charts illustrating signal sequences for motor operation and speed changes.

Multi-motor control

Explains how to operate multiple motors at the same speed using a single external potentiometer.

Repeated cycle of operation/instantaneous stop

Provides guidelines for motor operation in short cycles to prevent overheating.

Braking current at instantaneous stop

Lists braking current values for different motor outputs during instantaneous stops.

Alarms

Inspection

Troubleshooting and remedial actions