Oriental motor MSC-1 - Introduction

−
2
−
Introduction
1 Introduction

Before use
Only qualied personnel of electrical and mechanical engineering should work with the product.
Use the product correctly after thoroughly reading the section "2 Safety precautions." In addition, be
sure to observe the contents described in warning, caution, and note in this manual. Do not use for any
other purpose. Oriental Motor Co., Ltd. is not responsible for any damage caused through failure to
observe this warning.

Overview of the MSC-1
The
MSC-1
is a speed controller for velocity adjustment of AC speed control motors.

Applicable motors
AC speed control motor (6 to 90 W)
Also read the OPERATING MANUAL for applicable motor.

Standard and CE Marking
The
MSC-1
is recognized by UL, and axed the CE Marking (Low Voltage Directive and EMC
Directive) under the EN Standards.
•
Applicable Standards
Applicable Standards Cettication Body Standards File No. CE Marking
UL 508 UL E91291 −
EN 50178 Conform to EN standards
Low Voltage Directive
EMC Directive
•
Installation conditions (EN Standard)
For use as a component within another device Overvoltage category: II
Protection against electric shock: Class II Pollution degree: 2
*
If your equipment requires conformance to overvoltage category III, supply the power via an insulated
transformer.
*
If your equipment requires conformance to pollution degree 3, store the speed controller in an IP54-compliant
enclosure.
•
Low Voltage Directives
This product is designed and manufactured to be incorporated in equipment.
•
EMC Directives
Refer to "4.4 Installing and wiring in compliance with EMC Directive" on p.7.

RoHS Directive
The products do not contain the substances exceeding the restriction values of RoHS Directive (2011/65/EU).

Checking the product
Verify that the items listed below are included. Report any missing or damaged items to the branch or
sales oce from which you purchased the product.
• Speed controller ................................................1 unit
• CN1 connector ..................................................1 pc.
• Instructions and Precautions for Safe Use ........1 copy