Orion COBALT Series - Distorted Output Troubleshooting; Poor Bass Response Troubleshooting; Fuse Blowing Troubleshooting

Distorted output
Internal crossover not set properly Readjust crossovers. Refer to the "Internal Crossover" section of this
for speakers ___manual for detailed instructions._
Speakers are blown
Check system with known working speakers and repair or replace as needed.
Poor bass response
Speakers wired with wrong polarity
causing cancellation at low frequency
Crossoverset incorrectly
Impedance load at amplifier is too low
Battery fuse
blowing
Short in power wire or incorrect wiring
Check speaker polarity and repair as needed,
Reset crossovers. Refer to the Internal Crossover Configuration section of
this manual for detailed instructions. __
Check speaker impedance load, if below 2 Ohms stereo or 4 Ohms mono
rewire speakers to achieve a higher impedance. _
Check power and ground connections and replace or repair as needed.
Amplifier fuse
Fuse used is smaller than recommended
Too much current being drawn
Too much current being drawn
Replace with proper fuse size. _ , _
Check speaker impedance load. If below 2 Ohms stereo or 4 Ohms mono
Rewire speakers to achieve a higher impedance. _
Check power and ground connections and replace or repair as needed.
blowing
Check speaker impedance load. If below 2 Ohms stereo or 4 Ohms
mono, rewire speakers to achieve a higher impedance and replace with
recommended size fuse.
Check power and ground connections and replace or repair as needed.
Fuse used is smaller than recommended
Replace with proper fuse size.
impedance load at amplifier too low
Check speaker impedance load. If below 2 Ohms stereo or 4 Ohms
mono, rewire speakers to achieve a higher impedance
Speaker is blown with shorted outputs
Check system with known working speakers and repair orreplace as
needed
page