Orion COBALT Series User Manual

This warranty is in effect for the original purchaser only. ORION will pay labor and material expense for covered items. ORION does not cover removal or instal¬
lation charges, payment of shipping charges to ORION, payment of OUT-OF-WARRANTY shipping charges, or damage to other property caused by any de¬
fects in this product.
For ail warranty and non-warranty service issues, please refer to your nearest Authorized ORION Dealer for assistance. If you require additional information dr
assistance regarding service repair issues, please call (480) 705-5600.
Exclusion
1. This warranty is in lieu of all other warranties expressed or implied
2. in no event will ORION be liable for any consequential damages resulting from the use of this product or
any defect of this product.
This Warranty gives you specific legal rights and you may also have other rights which vary from state to state.
SAVE YOUR RECEIPT!
page 7
iai
SPECIFICATIONS
AMPLIFIER SECTION
CS 100.2
CS 150.2
Power output 4 Ohm Stereo (watts)
50 watts
90 watts
Power output 2 Ohm Stereo (watts) 1
70 watts
140 watts
Power output 4 Ohm Mono (watts) 1
140 watts
260 watts
Distortion all channels driven
(from 20Hz to 20kHz)
<.05% THD
<.05% THD
Frequency Response
20Hzto20kHz 0.5 dB
20Hz to 20kHz 0.5 dB
Linear Bandwidth
6Hz to 50 kHz 3dB
6Hz to 50 kHz 3dB
Signal-to-noise ratio full bandwidth
©rated output power
>100dB
> 100 dB
Damping factor @ output connector
full bandwidth
>300 at output connector
>300 at output connector
Slew Rate
> 45V/ s
>45V/ s
Input sensitivity 3
150mV to 2.5 Vrms
150mV to 2.5 Vrms
Input impedance
10 ka
10k£2
Fuse type
25AAMPATC
20Ax 2 AMP ATC
page8

Orion COBALT Series Specifications

General

Brand	Orion
Model	COBALT Series
Category	Amplifier
Language	English