53
5. To end the remote access session, enter *99# on your touch-tone phone.
Full Arm
To full arm your security system from a remote location, please proceed as follows:
1. Access your security system as described in the “Remote Access” section.
2. After the main menu, has finished playing, enter *4# on your touch-tone phone. The
system will prompt:
"Exit started”
3. The main menu is prompted:
“System armed, press 0 to disarm, press * to hear again.”
4. To end the remote access session, enter *99# on your touch-tone phone.
Part Arm
To part arm your security system from a remote location, please proceed as follows:
1. Access your security system as described in the “Remote Access” section.
2. After the main menu, has finished playing, enter *1# for ‘Part arm 1’, *2# for ‘Part arm
2’ or *3# for ‘Part arm 3’ on your touch-tone phone. The system will prompt:
"Exit started”
3. The main menu is prompted:
“System armed, press 0 to disarm, press * to hear again.”
4. To end the remote access session, enter *99# on your touch-tone phone.
Disarm
To disarm your security system from a remote location, please proceed as follows:
1. Access your security system as described in the “Remote Access” section.
2. After the main menu, has finished playing, enter *0# on your touch-tone phone. The
system will prompt:
"System disarmed”
3. The main menu is prompted:
“Press 4 to full arm, press 1, 2 or 3 to part arm, press * to hear again.”
4. To end the remote access session, enter *99# on your touch-tone phone.
To Next Page
Loading...
