What to do if Orisec CP-20 shows Zone 01 Alarm?
If your Orisec Intercom System displays 'Zone 01 Alarm', it means the zone has recently been alarmed and is awaiting a reset. To resolve this, enter your user code and select ‘Reset Alarms’.
How to fix a tamper error on my Orisec CP-20 Intercom System?
If your Orisec Intercom System shows a tamper error for the bell, panel lid, aux, keypad, or expander, it means the device's lid isn't making proper contact. Check the lid of the device to ensure it is securely fastened.
What does 'Zone 01 Active' mean on my Orisec CP-20 Intercom System?
If your Orisec Intercom System displays 'Zone 01 Active', it indicates that the zone is reporting an open state to the main control panel. Check the device to ensure it is not a door or window that has been left open.
What does 'Zone 01 Tamper' mean on my Orisec CP-20?
If your Orisec Intercom System displays 'Zone 01 Tamper', it indicates that the zone's lid is not making a tight connection. Check the lid of the device to ensure it is securely fastened.
What to do if Orisec CP-20 Intercom System shows 'Confirm Devices'?
If your Orisec Intercom System displays 'Confirm Devices', it means a networked device on the security system has been removed. Contact the installation company.
Explains how to set the system to full arm mode for when the premises are unoccupied.
Details how to use part arming modes to protect predefined detection zones.
Provides steps to disarm the system by entering the protected area via the designated entry route.
Guides users to arm specific area sets within the system for enhanced security.
Explains how to part arm selected areas, allowing flexible arming configurations.
Describes how to disarm one or more areas before entering them via the designated entry route.
Outlines the procedure to reset the system after an alarm condition has occurred.
Explains how to reset the system after a fault condition has been detected and rectified.
General| Brand | Orisec |
|---|---|
| Model | CP-20 |
| Category | Intercom System |
| Language | English |
To Next Page
