digiBASE-E™ High-Performance Power-over-Ethernet Multichannel Analyzer / PMT Base for Scintillation Detectors
Bit Meaning
32
78 Has programmable external dwell voltage capability
79 No Peak Preset feature (M
3
CA and OASIS)
80 Programmable pulser (OASIS)
81 Programmable Vacuum/HV interlock (OASIS)
82 Programmable Current/HV interlock (OASIS) 0
83 Explorable Stabilizer (LIST_GAIN_ADJU, LIST_ZERO_ADJU)
84 Has programmable input impedance (MCS)
85 Advanced shaping-time feature has no CUSP (digiDART, DSPEC jr)
86 Selectable HV rise-time (SET/SHOW/LIST_HV_RISE) (SBS-60)
87 Explorable ADC_GATE settings (LIST_GATE, SET_GATE n)
88 Monitor command support (SHOW_MONI_MAX/LABEL/VALUE)
89 SMART-1 Detector support (SHOW_SMART_DET, SHOW_SNUM_DET, SHOW_HV_RECO)
90 Nuclide report (SET/SHOW_NUCL_COEF, SET/ SHOW_ROI_NUCL, ...)
91 Interactive Display Features Such as Nuclide Report
92 Advanced Stored Spectra (SH_SPEC_COUNT, SET/SHOW_SPEC_ID, MOVE)
93 SET/SHOW/LIST_VIEW in new ZDT and GATE routing MCBs with DPM or RS-232
94 Connected to MCB via RS-232 (slow) port
95 No SET_HV_POSI, SET_HV_NEGA, ENA_NAI, DISA_NAI
Beginning of 4th word
96 Low Frequency Rejecter (ENA/DIS/SHOW_LFR)
97 Resolution Enhancer (ENA/DIS/SH_RENHANCER, SET/SHOW_RETABLE idx,val)
98 SET_MODE_RELIST for Resolution Enhancer List Mode
99 Readable Sample mode time per channel (SH_TIME_SAMPLE)
100 Adjustable Sample mode time per channel (SET/LIST_TIME_SAMPLE)
101 List Mode data streamed and formatted as in digiBASE
102 Supports ETP mode (ENA/DIS/SHOW_ETP)
103 List Mode data streamed and formatted as in DSPEC Pro
104 SET/SHOW/LIST_PZ using floating point microseconds
105 Risetime, flattop width and cusp not user changeable from property page
106 High Voltage not user changeable from property page
107 Coarse and fine gain not user changeable from property page
108 PZ and flattop tilt not user changeable from property page
109 LFR not user changeable from property page
110 Synch List Mode is available
111 DSPEC-PRO Auxilliary BNC input available
112 SET_DISPLAY is NOT used to select ZDT data view
To Next Page
Loading...
