ORTEC digiBASE-E - Index

65
INDEX
About tab ............................. 21
Acquisition presets ...................... 22
ADC setup ............................ 18
Amplifier settings .................... 17, 18
Attach to digiBASE-E.................... 10
Coarse gain jumper ...................... 61
Connection failed message ................ 23
Daisy chaining........................... 7
Dead time calculation .................... 18
DHCP server
obtaining a dynamic IP address .......... 10
digiBASE-E
Attach ............................. 10
coarse gain jumper.................... 61
ensure network interface card enabled ..... 10
front and rear panels.................... 5
hardware properties in MAESTRO ....... 17
IP addressing ........................ 12
MCB Configuration program............ 14
moving to a different network ........... 16
multiple users ........................ 16
password to limit access ................ 16
Ethernet Device Controller program
Attach to digiBASE-E(s) ............... 10
connection failed message .............. 23
incompatible IP address ................ 23
socket error ......................... 23
Event counter ..................... 6, 19, 22
SET_GATE......................... 45
Feature mask bits........................ 29
Flattop width
valid settings ........................ 18
Gain .............................. 17, 61
Gain stabilization........................ 20
Gate
AcqControl ....................... 6, 19
AcqTrigger ....................... 6, 19
CoincGate ........................ 6, 19
EventCounter ...................... 6, 19
none (off) ......................... 6, 19
Routing .......................... 6, 19
SET_GATE......................... 45
SET_VIEW ..................... 6, 7, 48
Sync................................ 7
SyncMaster .......................... 7
High voltage ........................... 21
InSight Mode........................... 18
mark types .......................... 18
Installation.............................. 7
ensure network interface card enabled ..... 10
quick-reference ....................... 8
IP addressing ........................... 12
dynamic (automatic)................... 12
incompatible IP address ................ 23
lease time........................... 14
Note - dynamic addressing .............. 10
Note - static addressing ................ 13
socket error ......................... 23
static (manual) ....................... 13
static - moving to different network ....... 16
List Mode ............................. 63
Lower level discriminator (LLD)............ 19
MCB Configuration program............... 14
Network
moving to a different network ........... 16
Network interface card - enable ............. 10
Password protecting settings and data ........ 16
Pileup rejection ......................... 17
PMT pinouts ............................ 5
Presets................................ 22
Resolution ............................. 18
Rise Time ............................. 18
valid settings ........................ 18
Socket error............................ 23
Status tab.............................. 22
Throughput ............................ 18
Troubleshooting ......................... 23
connection failed ..................... 23
incompatible IP address ................ 23
MAESTRO/ScintiVision-32 issues........ 26
socket error ......................... 23
Upper level discriminator (ULD)............ 19
Zero stabilization........................ 20