Monitor Settings
36
to choose a LUT file from SD card, the User LUT file list is as shown
in Figure 5.2-9, you can only see LUT ID without profile name in the
list for the first time.
Figure 5.2-9 LUT Storage Directory
Scroll the joystick down to select
LOAD USER LUT
item, and press it
straight down to enter the list, then scroll down to select a designated
LUT file, and press the joystick straight down to confirm the selection.
Then, it will pop up a prompt for reminding you overwriting operation
for LUT file, as shown in Figure 5.2-11, press
OK
and select the
target LUT from SD card, the file should be a LUT file with “.cube”
suffix, and specify its storage directory, please don’t cut off the power
during loading.
To Next Page
Loading...
