Monitor Settings
37
Figure 5.2-10 Prompt for Overwriting LUT
Figure 5.2-11 Calibration USER LUT Directory
For example: Load a LUT file to
LUT1
, scroll down to select
LUT1
in
the LUT list, press the joystick straight down to confirm the selection,
it will pop up a series of directories for navigating to the designated
LUT file, as shown in Figure 5.2-11, then choose a target USER LUT
to be stored. Press the joystick straight down to confirm the selection,
it will write the specified LUT file into the monitor from the SD card, it
will prompt the writing status, as shown in Figure 5.2-12, then it will
prompt file write complete after file loading. At last, you can see the
profile name is on the left side of the current LUT ID in the list.
To Next Page
Loading...
