Scenes and Tools
63
Refer to “5.2.3 Camera Profile” for the details of the COLOR
MANAGEMENT settings and versatile color profiles.
2. User LUT File
If you want to apply a USER LUT tool to current signal displayed on
screen, you should load the USER LUT in monitor settings at first.
First, write the designated LUT file to the monitor.
Operation: Select
camera profile
LOAD USER LUT
LUT*
item
in monitor settings, thus you can choose a LUT file from SD card, and
you can see LUT ID in the list. Choose one LUT ID, then it will pop up
a prompt for reminding you overwriting operation for LUT file, as
shown in Figure 6.1-21, press
OK
and select the target LUT from SD
card, the file should be a LUT file with “.cube” suffix, and specify its
storage directory, please don’t cut off the power during loading.
Figure 6.1-21 Prompt for Overwriting LUT
To Next Page
Loading...
