Scenes and Tools
64
Figure 6.1-22 Calibration USER LUT Directory
It will prompt file write complete after file loading. Then, you can see
the profile name is on the left side of the current LUT ID in the list.
You can load up to 10 USER LUTs into the device, for example as
shown in Figure 6.1-23.
Figure 6.1-23 User LUT List
Second, apply USER LUT in the tool. Select and enable a USER LUT
tool in a scene, and select
ID
item to your designated, the LUT name
will be displayed in
USER LUT NAME
in gray, as shown in Figure
To Next Page
Loading...
