oset MX-10 Mk.1 - Troubleshooting Common Issues; Common Problems and Solutions

28
If you have a problem with your OSET it is likely that there is a simple soluon to it.
If the above table has not solved your problem, on the next page you will see a diagnosc
ow chart, this will help idenfy what is stopping your bike from running correctly.
There is also a wealth of informaon and technical videos that can be found on the support
secon of www.osetbikes.com. These show how to carry out various checks.
If you have any queries please do not hesitate to contact your local dealer or the OSET
Customer Service Department.
ISSUE LIKELY CAUSE SOLUTION
There are no lights on the
throle.
Lanyard not present, key
switch not on.
Baeries not correctly
connected.
Baery voltage too low.
Check key and lanyard are present
and key turned to the ‘ON’
posion.
Check baery connecons.
Fully charge baeries.
Rear wheel only parally
rotates.
Faulty relay.
Main fuse blown.
Replace relay with known working
part.
Recfy issue and replace fuse.
Bike has a lack of power
and dials have no eect.
Faulty control dials. Replace control dials with known
working parts.
No power at the rear
wheel with throle lights
on.
Motor over heated
Faulty relay.
Faulty throle.
Faulty controller.
Allow bike to cool.
Replace relay with known working
part.
Replace throle with known
working part.
Replace controller with known
working part.
Poor run me. Baeries not fully charged.
Old baeries.
Mechanical fricon.
Charge baery for 12 hours.
Replace baeries.
Check brakes, bearings, chain.