oset MX-10 Mk.1 - Dial Adjustments for Rider Settings; Speed, Power, and Throttle Response Dial Functions; Dial Adjustment Safety Precautions

13
DIAL ADJUSTMENT
THESE DIALS ARE TO BE ADJUSTED BY A RESPONSIBLE ADULT ONLY.
SPEED DIAL
Speed liming device for novice riders
This motorcycle is equipped with a speed liming device to restrict top
speed. Use the device unl the rider becomes familiar with operang
the motorcycle
The speed dial is located underneath the rubber bung for convenience.
This must only be changed by a responsible adult. When dial is turned to
the fully clockwise posion, the bike will have a maximum speed, when
in the an-clockwise posion the speed will be reduced to its minimum.
POWER DIAL
This is the most important adjustability feature on the bike and must
ALWAYS start with the lowest seng, and make changes in very small
increments. It may appear that the highest power will be suitable for an
advanced rider, but it must be understood that there is a lot of power
available.
It is a great feature to have such a range available, but it MUST be
treated with respect. ALWAYS adjust from lower to higher, in very small
increments.
THROTTLE RESPONSE DIAL
It must be treated very carefully as the range of adjustability is
enormous.
The funcon of this dial is to adjust the ‘response’ of the bike. Fully
an-clockwise will give the slowest throle response. Fully clockwise
will give the quickest response.
Always check the dial sengs before the rider gets back on to ensure the desired seng is
correct for the abilies of the rider. The dials are sensive to small adjustments, do not
guess at changes.
CAUTION
Keep clear of all moving parts when checking dial sengs. Failure to do so could result in
serious injury.
WARNING