oset MX-10 Mk.1 - Riding Safety and Operational Precautions; Hot Surfaces and Intended Use

6
HOT SURFACES
During extended periods of use or if your OSET is ridden hard then some parts will get hot,
see highlighted areas in the image below.
- Do not touch the brake rotors or motor before they have cooled down.
- Let the bike cool down before carrying out any work.
INTENDED USE
Your OSET has been designed to be used in sports motorcycle compeons, or in a
supervised and authorised pracce environment.
Please follow all safety notes in the manual and ensure riders are of the correct age and
weight, the bike is correctly maintained, riders are always supervised and the bike is ridden
in appropriate condions.
SAFETY MODE
If the motor gets too hot the controller will limit the power to the motor unl the
temperature reduces to a safe level. If the motor temperature reaches a level which may
damage the motor then all power to the motor will be removed. Allow the bike to cool for
15 minutes , turn the bike o/on and you will be able to resume riding.
If the controller believes that an electronic component is behaving abnormally it will enter a
safe mode and stop power to the motor. If this occurs, stop riding and check the bike for
obvious signs of damage or faults. Once you have resolved the problem to restart the bike
you simply need to turn the bike o and on again. If the problem persists please take your
bike to an authorised OSET dealer for inspecon.
Risk of burning. Allow bike to cool before touching hot
surfaces.
WARNING
Motor
Brake disks