Welding GB
41
CPTX 270/CPTX 330
8.7 Anti-Stick-Function
With a sufficient wire speed the anti-stick-function switches on automatically.
Warning: During the welding process the switch for the regulation of welding current should
not be changed. The side door and the top panel of the power source should not be opened
or removed during the welding process.
When exceeding the set welding time or in case of overheating, the thermostat of the
machines switches off automatically (the yellow light is on and only the ventilator is rotating).
In this state it is impossible to weld!
Please wait until the device is cooled down and turns on automatically (the yellow light
switches off).
Important! Never turn off the power source during the cooling process!
To Next Page
Loading...
