25
7.1.7 Training Mode Indicator
The Training Mode indicator ashes when the Control Unit is in Training Mode.
The Training Mode is used to increase your muscle strength and endurance, and
to inhibit spasticity. In Training Mode the ActiGait® Implant is cyclically activated
without an input from the Heel Switch, e.g. during sitting or lying down. Training
Mode will automatically be turned o if the Heel Switch is activated during training
so Training Mode cannot be used for walking. The duration of each activation cycle
is set by your clinician. Consult your clinician for advice about when and how to use
training mode.
The Training Mode indicator.
You must be sitting or lying down during training. You must wear the Antenna and
Control Unit but you do not need the Heel Switch. Training Mode is switched o by
pressing the on/o button on the Control Unit for 1.5 seconds.
Switch o your Control Unit if it is on.
Sit or lie down in a comfortable position with
the Antenna mounted on your leg and connected
to the Control Unit. You do not need the Heel
Switch.
To Next Page
Loading...